In the process of word document creation, some pictures are added, but after adding, it is found that the pictures in the document are blank or cannot be displayed. Do you know what to do if the pictures cannot be displayed after inserting them into the word document? The following are some relevant materials I sorted out about the inability to display after inserting pictures in word documents for your reference.
1. First, we open the document of word2007 version, then click the "office button" above the document, and then select "word option" in the menu;
2. Press down and click the "advanced" option on the left, then find the "insert / paste picture as" option under the "cut, copy and paste" tab on the right of the window, and select the "float above the text" option. Similarly, under "display document content", remove the check in front of the "display picture box";
3. After setting, select any picture to insert, click the "compressed picture" button at the top left, and then remove the tick in front of "only apply to the selected picture" in the pop-up box;
4. Continue to click the "options" button on the "compressed picture" interface, tick the "automatically perform basic compression when saving" and "delete the clipping area of the picture" below, and click the OK button to exit.
1. The advantage of this method is that it will not change the properties of the formula, and it will not change the properties of the formula one by one. Select the text in the formula.
2. Then click "font size", select the font that meets the requirements, point to the font with the mouse, and the font in the formula will change dynamically. At this time, you can dynamically observe whether the line spacing meets the requirements. When the requirements are met, select this font size.
3. In addition, if the font size is not specified, it will be easier. Directly select the text, and then click a with inverted triangle in the upper menu bar, and the font will be reduced dynamically until the adjustment is satisfactory.
Method 3: use page setup to change the line spacing
1. Select the formula to be changed, and then click "page layout" in the menu bar.
2. Then there is a small arrow at the bottom of the page layout, as shown in the red box. Click this arrow to enter "page setting".
3. In the page setting, click "document grid" and then click "None"